The new T-Rex Miner stable version is ready.
You can download T-Rex Miner 0.25.12 from here:
Inside the archive you will find a file README.txt with installation instructions.
Make sure to replace the pool and wallet address by what you’re using in all files.
ethash) Improve LHR unlock functionality (dual modes and autolykos2 LHR performance is unchanged) Expect about 78-79% in normal mode, and 75% in low power mode (see
- Change default value of
--lhr-autotune-modeparameter to down (used to be full)
- (Linux) Memory temperature is not displayed on some GDDR6X cards
Make sure you remove any
--lhr-tune settings you may have in your existing configuration. The miner will calibrate the unlocker and the hashrate should go up to its normal level in about a minute after the miner displays calibration finished message.
Linux - 470.xx or newer
Windows - 512.xx (although 472.xx works fine too)
A few tips if you experience frequent LHR locks:
Make sure you don’t have monitors connected to your LHR cards, or at least turn them off during miner start up to let it calibrate correctly. Avoid using RDP if it puts load on your LHR cards.
Do not delay applying overclock - this will mess up calibration results and the miner will display unrealistically high LHR tune values.
Try reducing memory overclock of the GPU that frequently trips LHR.